Mounting assembly for encoder series 14 to size NEMA 256

Part number

 9 0 9 2
 
 
 
 

3D AutoCAD drawing of bracket (zipped)   -   DWG = [R13] [R14] [R2000]       DXF = [R13] [R14] [R2000]
Mounting Instructions
Mount fixture to the encoder with three self-tapping 
M6 x 10 screws and three No. 6.2 washers.
Slide the encoder onto the shaft.  With two 1/2-13  
screws, tighten the encoder fixture to the motor-frame 
or machine.
With the setscrews, tighten the hollow shaft encoder 
onto the shaft with a minimum clearance of 1/16" 
between fixture and encoder by bending
the fixture arms as required.

Connect the encoder as per wiring specifications.
Make sure power supply is within the proper voltage and 
current rating.
Encoder can be mounted with the setscrew on the machine 
side or on the opposite side for either CW or CCW.
See datasheet for CW and CCW directions of the outputs.
Technical data
0.3 mm stainless steel sheet 
three self-tapping M6 x 10 screws
three No. 6.2 washers
1 800 295 5693

UK   + 44 01978 363888

BR   55 01938 775214