Assembly for encoder series 55/IN85 to cage

Part number

 9 0 9 7
 
 
 
 
3D AutoCAD drawing of bracket (zipped)   -   DWG = [R13] [R14] [R2000]       DXF = [R13] [R14] [R2000]
Mounting Instructions
Mount fixture to the encoder with three self-tapping 
No. 8 screws and three No. 8 washers.
Slide the encoder onto the shaft.
With the setscrew, tighten the hollow shaft onto the shaft.
Mount the tether on the machine or motor-frame.
The tether can be bent to adapt to any surface.
This assembly allows the encoder to float and 
increases the lifetime of the bearings.
Connect the encoder as per wiring specifications.  
Make sure power supply is within the proper voltage 
and current rating.
Encoder can be mounted with the setscrew on the 
machine side or on the opposite side for either CW or CCW.
See datasheet for CW and CCW directions of the outputs.
Technical data
0.3 mm stainless steel sheet
three self-tapping No. 8 screws with phillips head
three No. 8 washers
.
1 800 295 5693

UK   + 44 01978 363888

BR   55 01938 775214