Mounting assembly for encoder series 90

Part number

 9 0 9 6
 
 
 
 
 
 
 
 

3D AutoCAD drawing of bracket (zipped)   -   DWG = [R13] [R14] [R2000]       DXF = [R13] [R14] [R2000]
Mounting Instructions
Mount fixture to the encoder with two self-tapping M6 x 10 screws and two No. 6.2 washers.
Slide the encoder onto the shaft.  With two 1/2-13 screws, tighten the encoder fixture to the motor-frame or machine.
With the setscrews, tighten the hollow shaft encoder onto the shaft with a minimum clearance of 1/16" between fixture and encoder by bending the fixture arms as required.
Connect the encoder as per wiring specifications.
Make sure power supply is within the proper voltage and current rating.
Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW.
See datasheet for CW and CCW directions of the outputs.
Technical data

0.3 mm stainless steel sheet 
two self-tapping M6 x 10 screws
two No. 6.2 washers

1 800 295 5693

UK   + 44 01978 363888

BR   55 01938 775214